sorry for posting this if it has already been covered, i searched but didnt see an answer..
on the hunt list option. if you have 6 lines configured, how do you stop line one from hunting to the rest of the list if nobody answers the line. is there a dial command option i can add on line 1 that says if not answered dont hunt but if busy hunt..
Submitted by eeman on Thu, 05/20/2010
Permalink
no, timeout and busy are the same failures so it will proceed in dialplan. Is this supposed to go to a PBX or act as if its analog phone service? Set the timeout very high (120 seconds?) and the calling carrier will probably (most likely) tear the line down by then.